For a light tint just wipe the excess stain off after a few minutes. As for a finish you have a couple of choices.
Working With Lacquer
All About Polyurethane How To Apply Polyurethane Finishes
Minwax Floor Stain Download By Minwax Wood Stain Drying Time
In general for a penetrative stain allow one to two says drying time and then test.
Wood stain drying time between coats. If its the fast drying stain yes you probably could but then again it depends on the glaze. Furniture cabinets doors trim and molding. Some wood stains can be coated in less than 1 hour whereas other stains take overnight drying.
Spray lacquer or polyurethane. Stains and drying times. You can probably do 15 coats of spray lacquer in the same amount of time as two coats of poly.
Smooth the top surface by sanding lightly with 400 grit lubricated sandpaper. Some can be coated over when you complete the brushing out. Water based stains are available in 50 wood tone and decorator colors.
Take your time finishing. Since some of the solvent absorbs into the wood it takes time for this to totally evaporate and dry. You must brush or wash paint pad applicators before use to remove loose bristles.
Allow the stain to penetrate 5 to 15 minutes. Dip a pad of 0000 steel wool into paste wax and carefully rub with the grain. Check the label on your can or call the supplier.
There are many instances we can be beneficial to speed up the drying time if you would stain and also your wood finishes. Spray lacquer generally dries in about a half hour. It is fast drying low odor and can be easily cleaned up with soap and water.
Latex stains will probably take even longer maybe even two or three weeks. 120 180 or 220 grit sandpaper for sanding raw wood. Minwax water based wood stain good for.
For a non penetrative stain leave for a week or more before applying a second coat. Here are a few easy techniques to make that happen. Youd want to do a couple coats.
If you applied the stain correctly and it still remained tacky it could be due to rainy weather or high humidity. Wait time between coats. Give it a few more days to see if it improves.
320 or 400 grit sandpaper or superfine sanding sponges for buffing in between coats of top coat. This is how to speed up wood stain dry time. If the stain isnt dry as matt said you will get siftening of the stain and possibly lift off which will result in light spots on your wood and will also contaminate your poly.
Minwaxs poly is a fast drying formula taking about 4 6 hours between coats. For deeper richer color wait as long as 15 minutes. Do the edges first separately as it is hard to rub all the way to the very edge of a surface.
Sand only enough to smooth and dont over sand. The longer the stain is left on the wood the deeper it will penetrate. 1 2 hours between coats.
Allow the wood to dry completely sand the piece down to bare wood and apply a coat or two of stain wiping off any excess.
Rust Oleum Weather Gray Ultimate Wood Stain 32 Fl Oz Walmart Com
One Time Deck Stain Stainless Timekeeper Mod Between Cleaning And
Working With Lacquer