I have a makita 6408k drill which appears to have no retaining screw for the chuck. Place the chuck on the spindle and retract its jaws completely.
How To Remove A Seized Stripped Or Stuck Drill Chuck On A Makita
How To Remove Or Change A Drill Keyed Chuck To A Keyless Chuck
Makita Usa Product Details 763174 5
Position the drill on a surface that allows the chuck and allen wrench to overhang the edge.
Makita chuck removal. Purchase a chuck that matches the. Cant get the keyless chuck off cordless makita 6095d drill. First its important to point out that drill chucks come in two basic kinds.
When i try to insert a large bent allen wrench into the chuck and hammer counterclockwise to remove the chuck the chuck just spins with the wrench. Check drill manuals or diagrams to find out what kind of chuck it is first because the steps for removal are different for each chuck type. Remove the entire spindle.
Before you begin removing the old chuck be sure to unplug the drill or remove. Im a long way from a service center and any suggestions would be appreciated. While securely holding the drill against the work surface strike the exposed end of the allen wrench with a hammer.
How to replace a makita chuck. Place a thin piece of wood over the chuck nose to protect it then tap the chuck nose with a mallet until it fits securely onto the spindle. Im trying to remove the chuck to separate the housing to determine why the drill will not run.
How to remove a drill chuck. If this is a newer tool it is probably a torx drive screw usually a t20. First shift the gear selector to the low setting and the clutch to the drill only.
Replacing a makita drill chuck is the same as replacing most other brands of drill chucks. Clean and degrease the tapered portions of the spindle and chuck. Threaded on chucks and 2.
I have a makita drill model number 6095d. The key is getting the chuck to release from the spindle after removing a screw that secures the chuck. This feature is not available right now.
Is there another way to remove the chuck. I have removed the screw that is inside the chuck but cannot remove the chuck itself. How to remove and replace a drill chuck threaded spindles are more common than tapered ones.
Eventually when enough of the screw head has been removed the chuck will break free from the spindle. Insert a screwdriver or allen wrench into the open chuck until it contacts. Once you remove the faulty chuck take it to a makita dealer or a home improvement center.
The screw is lh thread and after removing it you will need to put some screws back in tool to remove the chuck. Please try again later. The chuck is stuck in the open position cannot manually close it either and needs to be replaced.
Makita Cordless Drill Repair Lithium Ion Battery Repair Vilimiteva
Makita Usa Product Details 763198 1
3 Ways To Change A Drill Chuck Wikihow