website hit counter

How To Build A Bulkhead Around Pipes

In Wood 58 views

Learning how to build a soffit around duct work is not a difficult process and there are many ways to do it. Once the ladders are all installed to the bottom of the floor joists you simply connect the bottom of the soffit ladders to either a wall or an opposing soffit ladder to complete the soffit framing.

Amazon Com Rainpal Bbf020 Solid Brass Bulkhead Tank Fitting 1 2

Water Pond Products Pond Building Supplies Pond Plumbing

Basement Ceiling Ideas Basement Ceiling Installation

Measure the space between the two soffit walls.

How to build a bulkhead around pipes. Some ways are better than others and some methods are more preferable depending your specific situation. In order to do so mark a few 22s to fit across the bottom of the two ladder sections spaced to the size of the duct plus 1 on each side for clearance. Transfer this measurement to a piece of 2 by 2 lumber and cut out the same amount of blocks as soffit studs.

Build a matching soffit wall and install it on the opposite side of the pipe in the same manner as the first wall. 4 now youve got two ladders that will form the sides of the bulkhead. A soffit is basically a box framed with wood and covered with wall board that surrounds existing duct work piping or beams.

To finish building the frame you need to attach the two bottom plates. I am trying to build a wall around a drainage pipe that goes along half the length of a wall close to the ceiling. Its recommended that you use a air framer gun to attach the ladders to the floor joists.

I would not like to waste all the space by moving the wall in by 6 or 7 inches to avoid the pipe.

What Is A Kitchen Soffit And Can I Remove It Home Remodeling

What Is A Kitchen Soffit And Can I Remove It Home Remodeling

How To Finish A Basement Framing And Insulating House Projects

Tags: #how to build a bulkhead around pipes

How To Build A Bulkhead
How To Build A Bulkhead
Boathouse beach house roofing flood damage repair
Must read×

Top